Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 2 answers
  • Subscribers 29 subscribers
  • Views 7655 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can not access web admin

Andrew Goyer

XG210

I am new to configuring firewalls so I am learning as I go.  So I was playing with bridging interfaces just to see how it works and I bridged port 1 and 3 together.  Then I want to go back to port 1 acting as the LAN alone so I changed the bridge config to ports 3 and 4.  Now I cannot access the web admin.  I consoled in with a cable and see my WAN and my bridge setup in interface config but my LAN seems to be disabled.  Is there anyway I can enable and/or reconfigure the port in the CLI. I only want to do a factory reset as a last resort as my backups seemed to have stopped working. Thanks in advance for any help. 



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    You can configure the interface via Console. 

    Check the first points after logging in via console (keyboard) or SSH. 

    There are points to enable the Config again.

    You "unbind" Port1 and reset the config of it. So basically Port1 has no config anymore. 

Reply
  • 0

    Hi,

    You can configure the interface via Console. 

    Check the first points after logging in via console (keyboard) or SSH. 

    There are points to enable the Config again.

    You "unbind" Port1 and reset the config of it. So basically Port1 has no config anymore. 

Children