Very basic setup questions - but I'm new to the XG series after years with the Cisco ASA. Have a block of 5 public IP's (248 subnet) assigned to the WAN interface on port 2. First IP is the firewall (.233) with all the LAN systems NATed behind it, I need to send the remaining 4 to 4 different internal (LAN) servers with specific ports on each. Example is 2nd public IP (.234) goes to the mail server at 10.1.1.4 with only SMTP, HTTP and HTTPS traffic allowed. On the ASA I would set up a static route (one to one NAT) between .234 and 10.1.1.4, set a rule allowing SMTP, HTTP and HTTPS and so on, but I'm not even sure where to begin on the XG 125 interface and the documentation is all over the board. Any help is greatly appreciated!
This thread was automatically locked due to age.
