Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 8391 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN setup not working no ping to local LAN port 2

Ray Smith

I have been working on setting up a SSL VPN.  The goal is to have an iPad remote access to connect as if it was on the ip range 10.0.3.1/25 which is port #2 LAN on the XG230 sophos.

I have followed https://community.sophos.com/kb/en-us/122769 but although it connects, it connects as 10.81.234.6 (in the Remote SSL VPN Range) not as a 10.0.3.x. even with

firewall is set for MASQ. I am obviously missing something any one with a suggestion?

the goal is to have the iPad connect only to the port #2 LAN segment.  I do not want it to connect to the Port #1 LAN at all, nor should any on the port #1 see it.

every device on the Port #2 LAN is fixed IP with the Sophos ip as the gateway.

 

 

 



This thread was automatically locked due to age.
Parents
  • 0

    Hi Ray,

    I would avoid leasing an IP address from port#2 DHCP scope for the remote users connected via SSL VPN, instead, I will suggest you should configure a firewall rule for routing traffic from VPN to LAN2 and vice versa. You can refer to, "create firewall rule" section of the referred KB article. 

    Thanks,

Reply
  • 0

    Hi Ray,

    I would avoid leasing an IP address from port#2 DHCP scope for the remote users connected via SSL VPN, instead, I will suggest you should configure a firewall rule for routing traffic from VPN to LAN2 and vice versa. You can refer to, "create firewall rule" section of the referred KB article. 

    Thanks,

Children