WEBSITE NOT AVAILABLE FROM LAN

Question

Good day, 
 
 Please, i noticed that my organisation's website is not reachable from the LAN but clients can reach it from the outside network. 
 
 i have configure a LAN (source) to LAN (destination) and action to ALLOW ALL but i still cant access my organisation website. This has been working , just stopped few days ago. 
 
 COULD YOU PLEASE ASSIST ?

Ronak Sheth · Answer

Hi IOFS Technology 
 
 Enable NAT on the firewall rule. 
 
 Good Luck!!! 
 Regards, Ronak.

Ronak Sheth · Answer

Hi IOFS Technology 
 You have configured wrong rule (Network Rule). 
 
 You have to configure business rule as following. 
 Source: LAN-Any 
 Destination host:184.168.235.94 
 Service: HTTP/ HTTPS or the port on which your website is working 
 Protected server: IP of your web server 
 Protected Zone: LAN 
 NAT: Enable 
 
 Good Luck!!! 
 Regards, Ronak.

Aditya Patel · Answer

Hi Ayodeji , 
 Could you check if you have created a Reflexive and applied NAT MASQ as per the configuration shown on the snapshot.

Aditya Patel · Answer

Hi ayodeji , 
 If the website is hosted in LAN , the server should a Private address instead of Public address. The public address is pointed to XG WAN interface ? The traffic must be going through the LAN to WAN and Back to LAN.

Ronak Sheth · Answer

Hi IOFS Technology 
 
 First sorry for the misleading solutions. Looking at your initial post and firewall rule I assumed your webserver is behind XG. 
 
 Base on your policy test result you should be able to access your website from Rule ID 8. Can you resend me the Policy Test- Test method firewall rule, packet capture result and the rule no 8? Source IP should be same during policy test and packet capture. 
 
 You can also try to create a new firewall rule on top of all rule as following. 
 
 Src Zone: LAN 
 Src Net: Any 
 Dst Zone: WAN 
 Dst Net: WebServer IP (preferred FQDN host) 
 Service: HTTP & HTTPS 
 Rewrite Source Address: Enable 
 
 Regards, Ronak.