Hello everybody and thank you for your support
I'm deploing a new couple of XG Firewals instead of two old UTM9 but i've found many problems on VLAN configuration.
This is my actual UTM9 configuration:
As you can see i've the ETH1 configured with 3 Vlans and everything works fine.
On the XG i'm trying to replicate my configuration creating 3 vlans on eth8
My first question is: why do i have to configure an ip on the physical ifc if i'm configuring vlans on that interface?
And why the only working vlan is the one on the same subnet of the physical interface?
If i connect something on 172.16.100.X subnet everything works fine, but on 172.16.90.X don't work.
The only firewall rule i've created is from (zone) LAN (host) VLAN100 network; VLAN90 network ---> WAN
My network topology is very easy, just 2 FW and 2 managed switch.
On the switches the port connected to the XG is configured in trunk mode.
I have to use only one cable between XG and Switches as is
The XG version is SFOS 17.0.6 MR-6
This thread was automatically locked due to age.
