Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 2751 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configure AP100 to use new XG after hardware failure

Stefan B

We have two AP100s in an environment being supported by a vm'd XG firewall.

Unfortunately, the main server the firewall was on died and the latest backup doesn't have the APs configured.

Is there a way to recover these AP's to have them imported into a new XG instance, ideally without needing to replace them (mainly because they are very high up and I am lazy to swap them out)?



This thread was automatically locked due to age.
Parents
  • 0

    Hi  

    There is no need to recover/replace these AP's that were previously used by your other XG. Assuming they are still connected to the same switch, which is connected to the new hardware, they should still come up and register properly on your new XG instance.

    Regards,

Reply
  • 0

    Hi  

    There is no need to recover/replace these AP's that were previously used by your other XG. Assuming they are still connected to the same switch, which is connected to the new hardware, they should still come up and register properly on your new XG instance.

    Regards,

Children
No Data