This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Is it possible to allow access to specific ports based on MAC address and block access to the ports for the rest?

This is for incoming connections from out. Basically, we want to have only a list of MAC addresses to access the services on these ports and the rest cannot access these ports. Is this possible?

This thread was automatically locked due to age.

Parents

0 Aditya Patel over 7 years ago

Hi David,

The request from WAN will be replaced with the MAC address of your ISP router or any L3 device in your WAN. So if you block that MAC address ,no internet access .

Regards,

Aditya Patel
Global Escalation Support Engineer | Sophos Technical Support
Knowledge Base | @SophosSupport | Sign up for SMS Alerts
If a post solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Aditya Patel over 7 years ago

Hi David,

The request from WAN will be replaced with the MAC address of your ISP router or any L3 device in your WAN. So if you block that MAC address ,no internet access .

Regards,

Aditya Patel
Global Escalation Support Engineer | Sophos Technical Support
Knowledge Base | @SophosSupport | Sign up for SMS Alerts
If a post solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 David David1 over 7 years ago in reply to Aditya Patel

I see. Alright then, is there any other way I can restrict access to a set of devices only?
Cancel
Vote Up 0 Vote Down

Cancel