Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 27 subscribers
  • Views 17568 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

wan load balancing configuration

utsav deshar

 I have a three Wan connection A,B,C. I want to load balance only two wan A and B for internet sharing and failover. The rest Wan C I want to assign it to the specific LAN for the dedicate internet.What rule I have to set for this scenario.



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Proudmore

    hank you for the reply.

    The detail configuration is ..

    Wan Link available:

    1. WAN A  8 MB

    2. WAN B  3MB

    3 Wan C 3MB

     

    LAN network

    192.168.9.0/24

    192.168.1.0/24

    Now I need the firewall rule that my LAN network 192.168.9.0/24 should use the WAN link A and B with load balancing and failover and my LAN network 192.168.1.0/24 should use the 

    WAN C internet with full dedicate internet of 3 MB so that my lan network 192.168.9.0/24 should not use my  WAN C Internet .

  • +1 in reply to utsav deshar

    https://community.sophos.com/kb/en-us/123579

    have a look at this link. In the NAT& Routing section for each rule, make sure to select primary and secondary gatway as required.

    Load Balancing and Failover is achieved by using Firewall Rules on XG.

    Always, do some test and then proceed with mass deployment.

    Regards