Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 1 subscriber
  • Views 22080 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Endpoint users can change settings

Ross86

Hi All,

Recently setup Enterprise console and configured policies for each category.

However most of the users are able to open the Endpoint and change their firewall settings,  strangely I installed the Endpoint on another laptop and configure firewall is greyed out...however it's in the same policies as the other PCs/Laptops.

I also have tamper protection enabled on all policies.

Any idea how to make it so users cannot change any settings?

Thanks

Ross

:54253


This thread was automatically locked due to age.
Parents
  • 0

    Hello Ross,

    the Allow all traffic option should not be available to normal users. But it seems that almost everything else is configurable and that enables them in effect to bypass the firewall. That SCF's version has been bumped to 3.0 (and the low level architecture has been attuned to Windows 8)  might indicate that it's not dead, OTOH there was nothing new (let alone exciting) in 3.0 and ever since its inception (or acquisition) it's been a Cinderella.

    Christian

    :54333
Reply
  • 0

    Hello Ross,

    the Allow all traffic option should not be available to normal users. But it seems that almost everything else is configurable and that enables them in effect to bypass the firewall. That SCF's version has been bumped to 3.0 (and the low level architecture has been attuned to Windows 8)  might indicate that it's not dead, OTOH there was nothing new (let alone exciting) in 3.0 and ever since its inception (or acquisition) it's been a Cinderella.

    Christian

    :54333
Children
No Data