This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cyberoam Reset

I just reset my cyberoam and I could no longer access it again. The device is not accepting admin as password in CLI mode. it is giving Authentication fail.

This thread was automatically locked due to age.

Bianson over 8 years ago

Hello,

You may need to open a ticket here. There is also a KB page which may help you.

Regards,

Bob
Cancel
Vote Up 0 Vote Down

Cancel
Deo Angelo Lim over 7 years ago

Hi,

Good day!

You may reset the password on CRLoader by using Console cable.

1. Reboot the device.

2. On CLI, press enter continuously until option for CRLoader appear and its always option 0.

3. Go to Troubleshooting button.

4. Reset to default password.

5. The reboot the device.

Warm Regards,

Deo
Cancel
Vote Up 0 Vote Down

Cancel
IT Dept13 over 6 years ago in reply to Deo Angelo Lim

Confirmed working!

Timing is a bit tricky, wait until immediately after the POST beep on the Cyberoam to try continuous Enter key press.

I had to do this after importing configuration and selecting "Overwrite"

Note to all: If importing only selective exported configuration, use "Preserve" option.

If not a full export, it seemingly overwrites all other config with "null" values.

Hence the need for a full recover / reset procedure.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
Deo Angelo Lim over 6 years ago in reply to IT Dept13

No Problem mate!

Warm Regards,
Cancel
Vote Up 0 Vote Down

Cancel