This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPsec, Problem getting it to work

Hello,

I am trying to setup IPsec at my work to connect to my home network. I can webadmin into my Astaro Gateway. I am following the guide ASCV9-ASGV7-Config and it feels like I am missing a step. I am wondering if you guys could recommend what to do or if you think I am forgetting something.

Also I did setup pptp and it worked for me but I would rather use IPsec.

thx,
Ben

EDIT: This thread should have been posted in the Remote Access thread.

This thread was automatically locked due to age.

0 Sammoe over 18 years ago in reply to maygyver

@maygyver

show my post....
I wrote what you must do, to work...
Cancel
Vote Up 0 Vote Down

Cancel
0 maygyver over 18 years ago in reply to Sammoe

Hi,

I am using real User, but it is not working.

Sven

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel
0 Sammoe over 18 years ago in reply to maygyver

Ok update to 7.004, now it works. If not then redefine User, connection and Paketfilter rules.

Paketfilter: User --> Internal Network - all
User must have an IP-Address.

Check the Configuration of the Client. Is there a route to the Internal Network?
(cmd: route print)

sam
Cancel
Vote Up 0 Vote Down

Cancel
0 maygyver over 18 years ago in reply to Sammoe

I am using 7.004 with ActiveDirectory Created Users.

When using these users within a packetfilter rule, communication ends up in the Default DROP rule.

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel