This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Windows XP Service Pack 2 and SSH/Astaro Sentinel

SSH/Astaro Sentinel 4.0 build 190's virtual adapter is not working any more after the installation of Windows XP Service Pack 2.
I tried both "IKE mode config" and "specify manually"with XP's firewall disabled - as long as "acquire virtual IP address" is enabled, no packet arrives at the VPN gateway and connection finally fails. With "acquire virtual IP address" disabled -> connected.
Tried another WinXP/SP1-laptop: virtual IP via "mode config" -> OK. Installed WinXP SP2 -> No Connection.

Can anybody help?

This thread was automatically locked due to age.

0 EdS over 21 years ago in reply to mgeramb

I can tell you that I had SSH Sentinel installed on a Windows XP SP1 machine, applied a beta copy of SP2 and Sentinel worked fine. Even when I installed the RC of SP2 Sentinel continued to work.

On two other machines that I went from SP1 to RC SP2, Sentinel no longer worked.
Cancel
Vote Up 0 Vote Down

Cancel
0 BertJanssen over 21 years ago in reply to EdS

i'm using the ncp entry client http://www.ncp.de without any problem [:)]
Cancel
Vote Up 0 Vote Down

Cancel