This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNAT IPv6 outside IPv4 inside, packet dropped

Hi all,

I'm trying to reach my webserver, wich is behind a UTM 9.308.
The WAN side of the UTM is IPv6, and the LAN side is IPv4.

I've added a DNAT rule, to change the destination that reaches my UTM on port 80, to the internal network.

I've also added an Any to Any allow rule in the Firewall (for excluding the firewall from this problem). But I still get an Default Drop.

When I search on the internet, I've found some website that tells me that my DNAT rule isn't good. But I don't really see the problem, can you guys help me out?

See the attached image for the UTM settings / logs.

Thanks (again),
Bart

Network:
Host (::5) WAN UTM (::11) LAN UTM (192.168.22.1) Server (192.168.22.12)

This thread was automatically locked due to age.

0 Scott_Klassen over 9 years ago

Glad you got it fixed Bart.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago

No packets are captured on eth0 (WAN interface) for the 192 (LAN interface) adress.

I think you've proven that WebAdmin's NAT rules cannot yet translate IPv6IPv4. Scorpionking scores again! Thanks for posting the result to help others, Bart! [;)]

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Mario Ostwald over 8 years ago in reply to Bart van Kampen

Hello could you explain that again, i want to reach my ipv4 camera over ipv6 wan interface.

Did you setup the business rule at ipv4 or 6 side?
Cancel
Vote Up 0 Vote Down

Cancel

DNAT IPv6 outside IPv4 inside, packet dropped

Submitted a Tech Support Case lately from the Support Portal?