This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RDP does not seem to be consistent

Hi,

I have configured 3 RDP connections from the internet into my network without a problem. I used DNAT and packet filter rules to get the connections in.

I now need to do 5 more connections but they do not seem to be working. Is there a connection limit I am not aware of or something like that, that is preventing me from setting up multiple RDP connections?

I have compared the settings from my 3 that are working to the 5 new ones and they are the same except for the obvious need for minor details.

Thanks,
Mike

This thread was automatically locked due to age.

0 clickmike over 15 years ago in reply to BAlfson

I have setup everything as described in post#10 and I did try to add a packet rule -> any -> RDP -> RDP Targets and this did not help.

I am still stuck with the amount of available RDP ports to use, the limit seems to be three, 3389, 3390 and 3395. How can I create more?

Mike
Cancel
Vote Up 0 Vote Down

Cancel
0 superbits over 15 years ago in reply to clickmike

Turned out to be a policy routes issue. Had to reconfigure the NAT to reflect the correct gateway.
Cancel
Vote Up 0 Vote Down

Cancel
0 krzychol over 15 years ago

Mike,
do you have "wide"open connection from inside to outside?
In "packet filter" rule #1 internal =>any=>any
Cancel
Vote Up 0 Vote Down

Cancel