Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 2 subscribers
  • Views 4362 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to setup full NAT

liug
I am trying to setup a full NAT, eg: internal 192.168.1.5, outside 1.2.3.4

The GUI isn't very clear. 

Traffic Source: (when I setup SNAT, I need to put internal address here. When I setup DNAT, I put "Any" here. What to do with full NAT?)

Traffic Service: (Again, is this for the outbound traffic, or inbound?)

Traffic Destination: 

Nat mode: full nat

Destination:
Destination Service:

Source:
Source Service:


This thread was automatically locked due to age.
  • 0
    Do I also have to put all the other 12 addresses on it as "Additional Addresses" in order for it to respond for them and pass thru?

    Yes.  You'll need to get rid of the Hosts like "hostname1-EXT" since those host definitions won't work for a DNAT traffic selector.  Only the "External [hostname1] (Address)" object created when you configure an 'Additional Address' on the External interface can be used for traffic hitting that interface. 

    Cheers - Bob