This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Policy Routing Help Please

Hi All

I am trying to move over from ASL 6.x to 7.x and have problem
On the 6.x box the "addtional addresses on an interface" were still "interfaces" on v7.x they are not selectable as interfaces. this is a problem (I think)

I had on the 6.x box a policy route which had an "additional address on an interface" as the source interface but in V7.x you cannot select the "additional address on an interface" as a source.

I do not know wether I'm being stupid or not but can anyone help ?

This thread was automatically locked due to age.

0 SilverSurfer over 16 years ago in reply to BAlfson

Hi Bob

No the Polycom is on the internal network and as such its GW device is the astaro boxen

Jeff
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 16 years ago in reply to SilverSurfer

I guess I'm not seein' it. Barry, what are we missing?
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to BAlfson

Dunno... I'm no expert on PBR... sorry

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 16 years ago in reply to BarryG

Barry, I was just looking at it as a routing problem.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to BAlfson

Well, I would have thought DNAT on the second IP would work.

SilverSurfer, do you have a Visio diagram of all of this?
I think that would help us understand what you need to acheive.

Barry
Cancel
Vote Up 0 Vote Down

Cancel