This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple External NICs?

I appear to be having an issue getting two separate NICs setup and working correctly as external interfaces.  The intent here is to use one external address for all regular traffic, and accept all Outlook Web Access traffic on the second interface.  The NIC cards are installed on the system, detected and appear to be functional.  We use DHCP to obtain our static IP addresses on each interface (limitation of the ISP – same limitation that prevents the use of IP Aliasing).  While just the primary NIC is green-lighted and running, everything runs as expected.  As soon as I activate the second NIC and it acquires the correct IP address from the ISP, I lose all internet connectivity.


Are there some sort of issues with having two separate NICs each having an external address?

A little bit more info: Connection map -> DSL Modem ---> Hub ===> NIC1 & 2 (Firewall) Integrated NIC ---> LAN.
"-" one Cat5 cable
"=" two Cat5 cables

Thanks for any ideas!


This thread was automatically locked due to age.
  • It would involve spending money, but could you put in another DSL connection for the second NIC? That would keep both the ISP and Astaro happy, and let you use policy based routing from V6 to route Outlook web access through the second NIC and everything else through the first.
  • Just set up an additional address on the original nic. I have 4 addresses commin over my single external nic. Not by my choice, i wanted to seperate them all, but it will help me expand later iguess with the consolidation. I too contacted Astaro about this. I currently have our pptp, wan and a second wan address (same supernet) going over the same nic. When i configured 2 nics, it brought my netwrok down because of routing issues.

    If you already tried this, my bad. I have a crappy 1 meg fractional t1 (for now) and haven't had to mess with dsl.